---

Using Web Editor V5 R14 SP6 I'm not able to check-out any CatParts, because I'm getting always the following warning :
Warning No: 24908 You are going to perform LifeCycle operation within SMARTEAM on objects created by CATIA integration(s).

and if I try to select the "Run" command, I continue to see always the same check-out page with the warning message in the top part of the page .
Trying to check-out a Catia V4 Model file , where an integration is not available, the operation is successfull .
Any hints about this problem ?

Eine Antwort auf diesen Beitrag verfassen (mit Zitat/Zitat des Beitrags) IP