/COM,ANSYS RELEASE  9.0    UP20041104       11:13:44    06/28/2006

 *** WARNING ***                         CP =       0.422   TIME= 11:13:48
 Use of the -M switch is no longer recommended for normal ANSYS use.     
 ANSYS now dynamically allocates memory as needed.  Only use the -M      
 switch if you are certain that you need to do so.                       

 *** WARNING ***                         CP =     169.531   TIME= 11:16:53
 Using 1 iteration per substep may result in unconvergent solutions for  
 nonlinear analysis and the program may not indicate divergence in this  
 case.  Check your results.                                              

 *** WARNING ***                         CP =     171.922   TIME= 11:16:55
 Element shape checking is currently inactive.  Issue SHPP,ON or         
 SHPP,WARN to reactivate, if desired.                                    

 *** WARNING ***                         CP =     177.484   TIME= 11:17:02
 SOLID186 wedges are recommended only in regions of relatively low       
 stress gradients.                                                       

 *** WARNING ***                         CP =     180.656   TIME= 11:17:05
 Material number 19 (used by element 380168 ) should normally have at    
 least one MP or one TB type command associated with it.  Output of      
 energy by material may not be available.                                

 *** WARNING ***                         CP =     220.672   TIME= 11:19:16
 Some contact elements (e.g.391132) overlap with other contact element   
 (e.g.391139) which can cause over constraint.                           

 *** WARNING ***                         CP =     223.406   TIME= 11:19:19
 The closed gap/penetration may be too large.  Increase pinball if it is 
 a true closed gap/penetration.  Decrease pinball if it is a false one.  

 *** WARNING ***                         CP =     223.406   TIME= 11:19:19
 The initial penetration/gap is relatively large.  Using bonded/no       
 separation option may cause an accuracy issue.  You may use the         
 CNCHECK,ADJUST command to move the contact nodes towards the target     
 surface.                                                                

 *** WARNING ***                         CP =     223.406   TIME= 11:19:19
 The closed gap/penetration may be too large.  Increase pinball if it is 
 a true closed gap/penetration.  Decrease pinball if it is a false one.  

 *** WARNING ***                         CP =     223.406   TIME= 11:19:20
 The initial penetration/gap is relatively large.  Using bonded/no       
 separation option may cause an accuracy issue.  You may use the         
 CNCHECK,ADJUST command to move the contact nodes towards the target     
 surface.                                                                

 *** WARNING ***                         CP =     223.422   TIME= 11:19:20
 The initial penetration/gap is relatively large.  Using bonded/no       
 separation option may cause an accuracy issue.  You may use the         
 CNCHECK,ADJUST command to move the contact nodes towards the target     
 surface.                                                                

 *** WARNING ***                         CP =     223.438   TIME= 11:19:20
 Overconstraint may occur for Lagrange multiplier or MPC based contact   
 algorithm.