---

Hallo,

I have the fault that the display shows 2222.222 or 20.000. or 20.00---0 as also Xaver discribed on the forem. If it is in this state the control does not react at all also It can be if I am in manual mode with one axe selected, and i  switch on 1 axe all 3 of them start moving!!!. Can this be the program in the Eprom is getting bad? It first was once every time I switched on but it getting worse and is now almost any time at switching on.

Does anyone know how to solve this problem. What is your suggestion?

Thanks in advance
Sorry for my englisch but my german is real bad.

Frans Trapman

Eine Antwort auf diesen Beitrag verfassen (mit Zitat/Zitat des Beitrags) IP

---

Hi Frans,

you got a reply onto your sent PM.

@all:
No, sorry! I have no solution. I just know, that an EPROM-error is listed as error #22, but I'm not sure, that this will be shown as 22222.222 on the screen, or display.

In fact, I've never seen a TNC 121 and my imagination is only driven and suggested by the error-list in this service-manual, not even more. Sorry!

Regards,
Nina

------------------
Nichts auf der Welt ist so gerecht verteilt wie Intelligenz.
Jeder ist der Meinung, genug davon zu besitzen. [René Descartes]
Ist das nicht wunderbar?!?       
System-Info | Bildschirmaufzeichnung | Creo 1 | Richtig fragen

Eine Antwort auf diesen Beitrag verfassen (mit Zitat/Zitat des Beitrags) IP