Hallo
Ich schreibe ein Code, die 4 - Blöcke erstellt (Beispiel_Bild1.pdf), danach möchte ich die Blöcke z.B. nach rechts verschieben und trennen von einander (Beispiel_Bild2.pdf). Jedoch ich habe keine Ahnung wie soll ich das machen. Für alle Tipps bin ich sehr dankbar.
(command "linie" spr9ul spr10ul "")
(ssadd (entlast) AW)
(command "linie" spr11ul spr12ul "")
(ssadd (entlast) AW)
(command "linie" spr13ul spr14ul "")
(ssadd (entlast) AW)
(command "linie" spr15ul spr16ul "")
(ssadd (entlast) AW)
(command "linie" spr17ul spr18ul "")
(ssadd (entlast) AW)
(command "bemlinear" ldo5l ldo6l bem5d "")
(ssadd (entlast) AW)
(command "bemlinear" untrech3 untrech4 bem8d "")
(ssadd (entlast) AW)
(command "_-block" "teil4xa" '(0 0 0) AW "")
(command "_-insert" "teil4xa" '(0 0 0) 1 1 0 0)
(setq X1 (entsel "\nObjekte zum Verschieben wählen: "))
Eine Antwort auf diesen Beitrag verfassen (mit Zitat/Zitat des Beitrags) IP